Aziz Bench

2.35 × 0.7 mm DC plug

EIAJ class 1, meant for up to 3.15 V: old phones and small low-voltage devices.

Connector
2.35 × 0.7 mm
DC plug · EIAJ class 1, ≤ 3.15 V
Outside
2.35 mm
Hole
0.7 mm
Length
9.5–13 mm
2.35 × 0.7 mm
2.35 mm0.7 mm2.35 × 0.7 mm

Specifications

Outside diameter2.35 mm
Hole diameter0.7 mm
Jack pin0.65 mm
Centre pin in the holeno
Barrel length9.5–13 mm
StandardEIAJ class 1, ≤ 3.15 V
Rating (catalogue part)PP3-012: 2 A, 20 V DC; Lumberg 1636 01: 2 A, 24 V DC
Polaritynot set by the size: read the symbol
PlugPP3-012 · Lumberg 1636 01

Lookalikes and how to tell them apart

Very close to the 2.5 × 0.7: measure the outside with a caliper. The 2.0 × 0.6 of old Nokia phones is thinner.

SizeCentre pinStandard
2.35 × 0.7 mmnoEIAJ class 1, ≤ 3.15 V
2.5 × 0.7 mmnode facto size
2.0 × 0.6 mmnode facto size

Before you plug it in

Measure with a caliper: the metal sleeve gives the outside diameter. For the hole, use drill bits as gauges: the largest one that slides in gives the size. If there is a pin in the middle, a bit won’t go in: use the caliper’s inside jaws.

The size says nothing about polarity: look for the symbol (a dot inside a C, with + and −) on the device and on the adapter. Centre positive is the most common.

In the EIAJ standard each voltage band has its own size, larger for higher voltages, so a plug won’t go into a jack for a lower band. A smaller plug can still enter a larger jack (class 2 into class 3), and outside Japan the bands aren’t always kept: read the label.

Open the connector identifier →Not sure it is this size? Enter the outside and hole diameters: the identifier compares 22 DC plug sizes.

Other DC plug sizes

All DC plug sizes, with a chart →

Frequently asked questions

Is 2.35 × 0.7 mm a standard size?

Yes: EIAJ class 1, ≤ 3.15 V.

Sizes and ratings from the makers’ catalogues (Same Sky, Lumberg, Switchcraft) and the EIAJ and IEC summaries. A plug’s rating is a maximum: the adapter’s label says what it actually supplies.