Aziz Bench

IRLML6344 as a switch with Arduino and ESP32

A 30 V SOT-23 MOSFET with RDS(on) guaranteed at 2.5 V (37 mΩ): one of the best small parts for a 3.3 V pin.

Transistor
IRLML6344
N-channel MOSFET · SOT-23 · Infineon
Max voltage
30 V
Max current
5 A
RDS(on)
37 mΩ at 2.5 V
SOT-23 pinout
3D1G2S

From a 3.3 V or 5 V pin

PinVerdictWhyIn free air
ESP32 · 3.3 VWorksRDS(on) at most 37 mΩ guaranteed from 2.5 V4.2 A (heat)
Arduino Uno · 5 VWorksRDS(on) at most 29 mΩ guaranteed from 4.5 V4.8 A (heat)

In free air at 25 °C, with the junction 25 °C below its 150 °C maximum and θJA 100 °C/W, at the guaranteed RDS(on) raised with temperature.

Specifications

TypeN-channel MOSFET
PackageSOT-23
Maximum voltage30 V
Maximum current5 A
Threshold VGS(th)0.5 … 1.1 V
RDS(on), maximum37 mΩ at 2.5 V (4 A) · 29 mΩ at 4.5 V (5 A)
Gate voltage limit±12 V
Gate charge6.8 nC at 4.5 V (typical)
Thermal resistanceθJA 100 °C/W
Maximum junction temperature150 °C
Datasheet usedInfineon

Pinout

PinFunction
1Gate
2Source
3Drain

Seen from above with the single pin (3) at the top: pin 1 is bottom left, pin 2 bottom right.

Similar parts

PartPackageRDS(on) at 3.3 VRDS(on) at 5 VMax voltageMax current
IRLML6344SOT-2337 mΩ29 mΩ30 V5 A
2N7000TO-92no5.3 Ω60 V200 mA
BS170TO-92nono60 V500 mA
AO3400ASOT-2348 mΩ32 mΩ30 V5.7 A
Si2302SOT-2375 mΩ57 mΩ20 V2.6 A
IRLZ44NTO-220no25 mΩ55 V47 A
IRLB8721TO-220no16 mΩ30 V62 A
IRF520TO-220nono100 V9.2 A
IRF540NTO-220nono100 V33 A

Tips

Keep the 10 kΩ from gate to ground: while the microcontroller boots its pins float and the MOSFET could turn on by itself.

Every coil needs a flyback diode across it, cathode to the positive supply. Without it the voltage spike at turn-off can destroy the transistor at the first switching.

An SOT-23 sheds its heat through the copper on the drain pin: the datasheet figure assumes about 6.5 cm² (1 in²), a bare pad runs much hotter.

Open the calculator →Check the IRLML6344 with your own load, supply, PWM frequency and temperature.

Other transistors

Frequently asked questions

Does the IRLML6344 work with a 3.3 V ESP32?

Yes: its RDS(on) is guaranteed at 2.5 V (at most 37 mΩ), and a 3.3 V pin is above that. In free air it handles about 4.2 A.

How much current can the IRLML6344 switch without a heatsink?

About 4.8 A from a 5 V Arduino pin, in free air at 25 °C, keeping the junction 25 °C below its 150 °C maximum (limit: heat).

What is the IRLML6344 pinout?

SOT-23: 1 gate, 2 source, 3 drain. Seen from above with the single pin (3) at the top: pin 1 is bottom left, pin 2 bottom right.

Source of the figures: Infineon datasheet (PDF)