MAX17048 / MAX17049 I²C address

How to set the address

There is no address pin: the address is set at the factory, so it is always 0x36.

Devices that use the same addresses

None of the other 87 devices in our list use these addresses, so the MAX17048 / MAX17049 rarely clashes with anything.

Check your whole bus →Add the MAX17048 / MAX17049 and your other modules: the checker finds conflicts, suggests free addresses and sizes the pull-ups.

7-bit and 8-bit address

I²C addresses are 7 bits long. Some datasheets and libraries write them as 8-bit numbers, with the read/write bit added on the right: that is why the same chip can appear as 0x36 or 0x6C. Arduino’s Wire library and ESPHome use the 7-bit form.

Check that it answers

Upload this sketch with the MAX17048 / MAX17049 wired to SDA and SCL: it tries every address the chip can use and prints the one that answers. On an ESP32 the default pins are GPIO21 (SDA) and GPIO22 (SCL); on an Arduino Uno, A4 and A5.

#include <Wire.h>

const byte ADDRS[] = {0x36};

void setup() {
  Serial.begin(115200);
  Wire.begin();
  for (byte a : ADDRS) {
    Wire.beginTransmission(a);
    if (Wire.endTransmission() == 0) {
      Serial.print("MAX17048 / MAX17049 answers at 0x");
      if (a < 0x10) Serial.print('0');
      Serial.println(a, HEX);
      return;
    }
  }
  Serial.println("No answer: check the wiring");
}

void loop() {}

In ESPHome the bus is scanned at boot (scan: true is the default): the log lists every address that answers.

i2c:
  sda: GPIO21
  scl: GPIO22
  scan: true

Pull-up resistors

SDA and SCL need pull-up resistors to the supply. Many breakout boards already carry them, often 4.7 kΩ or 10 kΩ, and with several boards on the bus they add up in parallel. The I²C checker works out the allowed range for your bus voltage and speed.

Similar devices

AXP192 AXP2101 BQ27441-G1 INA219 INA226 INA260 INA3221 IP5306

Addresses checked against the MAX17048 / MAX17049 datasheet.